FIRMWARE RELEASE NOTE ===================== Products affected: AXIS A1001 Release date: 2018-05-18 Release type: Production Firmware version: 1.65.1 File name: A1001_1_65_1.bin Preceding release: 1.65.0 Onvif support: Profile C, Profile A -------------------------------------------------------------------------------- Upgrade instructions ==================== Upgrade the firmware according to the instructions given at https://www.axis.com/ca/en/support/tecnical-notes/how-to-upgrade or howtoupgrade.txt, which is included in the firmware folder. If in an A1001 controller cluster make sure to upgrade all controllers. Either all at a time using ADM or straight after each other using web interface or FTP. The entire cluster always needs to be on the same Firmware! If you encounter any issues when upgrading firmware - Contact Axis tech support. Never Downgrade/roll back your firmware without a full factory default of your product! New features in 1.65.1 ====================== 1.65.1:F1 Generate activity remotely on a IdPoint with API. The IdPoint will interpret this as an actual credential and will run trough the system as if it was. 1.65.1:F2 New card encodings. Support for Big and Little Endian inversed byte order encoded as HEX or INT32. Corrections in 1.65.1 ===================== 1.65.1:C1 PullPoint subscription returns a subscription id over O3C or for HTTP port other than 80. 1.65.1:C2 Fixed critical vulnerability ACV-128401 Known Bugs/Limitations ====================== 1.65.1:L1 An upgrade takes longer than expected. In a used system it can take up to 10-15 minutes. 1.65.1:L2 When in a controller cluster It is not possible to have an action rule with additional conditions or working on any other schedule than Always(no schedule) Nor is it possible to trigger on events originating from another controller in the cluster. 1.65.1:L3 If you have offline controllers in a controller cluster and try to remove one of the units that is online this requires a majority of all controllers being online excluding the controller being removed. 1.65.1:L6 Pressing 'save' on Date & Time page in Axis Entry Manager doesn't update the ticking clock on the page even though time is set. Refresh the page to see the current set time. 1.65.1:L12 After a firmware update, the web browser cache may need to be cleared to avoid seeing pages originating from the old firmware. 1.65.1:L19 During start up of the device the web server is reachable before other sub- systems are operational, possibly resulting in AEM showing 'Failed to retrieve device info' on its overview page if accessed during this time. Reloading the page a few seconds later will resolve this issue.