PTZ DRIVER RELEASE NOTES
                 ========================

Release date: 2012-04-17

Release type: Production

Driver version: 2.08

Filename: Cohu-2.08-mipsisa32r2el-3_28-3_1.ptz

Previous release: 2.05

---------------------------------------------------------------------

Release 2.05
=============

2.05:1 Added calibration parameters for the tilt movement.
       Different Cohu models may have different tilt offsets and
       different number of tilt steps per degree.

2.05:2 Added calibration parameter ("Field Angle Compensation") for
       the zoom function (for calibration of different lenses).

2.05:3 Added support for Cohu ER8945 and Cohu ER8945A.


Known problems and limitations in version 2.05
==============================================

Note! Some limitations are also model dependent and can behave
      different on different Cohu models!

2.05:4 To use this version of the driver, firmware 4.47 or higher
       is required.

2.05:5 Tilt movement limits are sometimes exceeded during continuous
       movement when set close to the mechanical limits.

2.05:6 A camera address must already be assigned to a Cohu PTZ device
       before using it with this driver (the Cohu PTZ device have no
       DIP-switches for assigning camera addresses).

2.05:7 A zoom move will set autofocus=on. After a zoom move, a short
       delay is required before a manual focus move is possible.

2.05:8 When saving a preset in the Cohu PTZ unit ("device presets"),
       the digital zoom position is not saved (e.g. "device presets"
       are only saved in optical zoom area).

2.05:9 When saving a preset position, only pan, tilt and zoom positions
       are saved in the preset.