PTZ DRIVER RELEASE NOTES
                 ========================

Release date: 2007-11-16

Release type: Production

Driver version: 3.02

Filename: Cohu-3.02-crisv32-3_0-1_5.ptz

Previous release: 2.01

---------------------------------------------------------------------

Release 3.02
=============

3.02:1 Added calibration parameters for the tilt movement.
       Different Cohu models may have different tilt offsets and
       different number of tilt steps per degree.

3.02:2 Added calibration parameter ("Field Angle Compensation") for
       the zoom function (for calibration of different lenses).


Known problems and limitations in version 3.02
==============================================

Note! Some limitations are also model dependent and can behave
      different on different Cohu models!

3.02:3 To use this version of the driver, firmware 5.11 is required.

3.02:4 Tilt movement limits are sometimes exceeded during continuous
       movement when set close to the mechanical limits.

3.02:5 A camera address must already be assigned to a Cohu PTZ device
       before using it with this driver (the Cohu PTZ device have no
       DIP-switches for assigning camera addresses).

3.02:6 A zoom move will set autofocus=on. After a zoom move, a short
       delay is required before a manual focus move is possible.

3.02:7 When saving a preset in the Cohu PTZ unit ("device presets"),
       the digital zoom position is not saved (e.g. "device presets"
       are only saved in optical zoom area).

3.02:8 When saving a preset position, only pan, tilt and zoom positions
       are saved in the preset.