How to install it

Network connection

1. Attach a scanner to the network document server using a SCSI 2-cable. (Optionally attach a keyboard for manually entering e-mail addresses.)
2. Connect the network document server to the IP network using an Ethernet cable. 
3. The document server will automatically detect the type of scanner attached and show the name on the display at startup. All the drivers needed is included in the network document server. A list of all supported devices can be found on the AXIS 70U support pages.
4. Assign an IP address to the network document server, either automatically using DHCP or manually via the buttons on the control panel. The current IP address can be shown on the display. 
5. The network document server is configured using the Administration tools in the built-in Web interface. If you have an active DHCP or BOOTP server on the network, most network settings will be set automatically.

Mail server

• Specify the IP address of the SMTP mail server that handles e-mail facilities on your network.

E-mail addresses

• E-mail addresses can be referenced from an external address book on an LDAP (Lightweight Directory Access Protocol) server.
• You can also add e-mail destinations manually through the Web interface.

Access control

• If the network document server is located on a Windows NT network, standard NT methods can be used for user authentication.
• Authentication makes it possible to allow access to the network document server for authorized users only. If user authentication is used, the sender of scanned documents will automatically be set to the logged-in user.